Narishige Pc10 Manual New Jun 2026

Switches between STEP 1 (single stage) and STEP 2 (two-stage pulling).

While simple in design, this system allows you to preset two different heating levels—one for the initial stretch and another for the final pull—enabling the production of everything from long, thin microinjection needles to firm, blunt microelectrodes for patch-clamping. Key Specifications & Features

The Narishige PC-10 is a computer-controlled microinjector that allows for precise and controlled injection of liquids into cells or tissues. It is widely used in research applications such as intracellular recording, drug delivery, and gene injection.

Rotate the bottom switch 90 degrees counterclockwise to the "under weight" position (if applicable to your version). Press the red Start Switch narishige pc10 manual new

Clean your glass capillaries with ethanol and dry them thoroughly to remove finger oils and dust. Dust particles cause asymmetric breaks during the pull. Step 2: Install the Capillary

Narishige PC-10 is a vertical micropipette puller that uses gravity and automated two-stage pulling to create glass needles for microinjection and patch clamping. Tritech Research Key Controls & Components Mode-Selector Knob : Switches between four modes: : Starts single-stage pulling. : Starts two-stage (double) pulling. NO. 1 HEATER / NO. 2 HEATER

The manufacturer's FAQ pages and distributor specification sheets provide the most current official information for the PC-10. Switches between STEP 1 (single stage) and STEP

Houses the platinum heating coil. It features adjustable ventilation shields to control heat dissipation.

: Scientists would fine-tune their needles by swapping between two pairs of weights—light and heavy—to adjust the gravitational pulling force. The Transition to the "New" Manual (PC-100)

Press . The unit will heat continuously until the glass pulls apart in a single downward stroke. Dual-Stage Pulling (For Short, Rigid Patches) It is widely used in research applications such

Operation centers on balancing heat and pulling force to create the desired pipette. This is controlled by two primary parameters:

The PC-10 operates on the principle of gravitational pulling. A glass capillary is held vertically in a clamp. A heating element (platinum or nichrome wire) surrounds the glass. When the glass softens due to heat, a weight attached to the lower end of the glass pulls it downward, stretching the glass until it separates into two halves. One half remains in the upper clamp, and the other falls into a receiver, forming two identical microelectrodes.

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.

The story of the is one of a legendary laboratory workhorse that served as the global standard for micropipette fabrication for decades before its retirement. Known for its "gravity-fall" vertical pulling method, it allowed researchers to create ultra-fine needles for microinjection and patch-clamp experiments with remarkable consistency. The Legacy of the PC-10