skip to main content

Micronova Es99 User Manual (2026 Edition)

Compatible with LED (e.g., 3-button or 6-button variants) and LCD control panels via flat ribbon cable. 2. Operating Modes & Daily Usage

Clean ash buildup from the exhaust fan blades. Inspect the encoder wiring harness. AlT 5 / Er05 - No Ignition

The rear profile or internal board of the ES99 controller contains physical DIP switches. These must be toggled into correct positions during commissioning or replacement: : ON : Remote control interface activated. micronova es99 user manual

Enter the manufacturer access password (the standard baseline factory key for Micronova boards is often or 55 , depending on the specific firmware variant). Press Button 1 to open the parameter list. Core Parameter Reference Table (Pr) Parameter Code Description Typical Range Factory Default Pr01 Maximum time limit for a successful ignition 15 – 25 mins Pr02 Stabilization phase duration 2 – 10 mins Pr03 Interval duration between brazier cleaning cycles 20 – 120 mins Pr04 Auger motor ON time during ignition phase 0.5 – 4.0 sec Pr05 Auger motor ON time during stabilization 0.5 – 4.0 sec Pr06 Auger motor ON time at Power Level 1 0.5 – 3.0 sec Pr10 Auger motor ON time at Power Level 5 2.0 – 8.0 sec Pr11 Delay alarm time window for safety triggers 30 – 120 sec Pr13 Minimum exhaust temperature required to confirm ignition 40 – 60 °C Pr14 Maximum safe exhaust gas temperature threshold 200 – 270 °C Pr15 Temperature threshold to turn on the room air fan 50 – 70 °C Pr16 Exhaust fan speed setting during ignition 1000 – 2500 RPM Pr18 Exhaust fan speed setting at Power Level 1 800 – 1500 RPM Pr22 Exhaust fan speed setting at Power Level 5 1800 – 2800 RPM 5. Troubleshooting and Error Codes

ES99 Controller Manual * SaveSave Es99 Controller For Later. * 100%100% found this document useful, undefined. * 0%, undefined. ES99 Control by MICRONOVA - Radwell International Compatible with LED (e

Once a fault condition has been corrected, the controller must be explicitly cleared to resume operations.

: Lack of vacuum in the firebox (check the door seal or chimney for blockages). Technical Maintenance To access deeper technical settings (Parameter Menus), a Technical Access Code Inspect the encoder wiring harness

Red light illuminates; compressor shuts down instantly.