Cencom Gold Wiring Diagram -

Ignition Trigger (+12V switched power to turn the CenCom system on) White/Violet Input 1 (Programmable input, e.g., Park Kill / Brake Sense) Pin 7 White/Blue Input 2 (Programmable digital input) Pin 8 White/Green Input 3 (Programmable digital input) Pin 9 White/Yellow Input 4 (Programmable digital input) Pin 10 Output 1 (Low current, programmable logic output) Pin 11 Output 2 (Low current, programmable logic output) Pin 12

Never replace a blown fuse on the ARM with a higher-rated fuse. Match the diagram's specified amperage exactly.

Route the multi-conductor communication cable from the cockpit to the amplifier module. cencom gold wiring diagram

Locate a verified +12V ignition-switched source using a multimeter. Connect this to of the 12-pin connector. The CenCom will not power up or program without this receiving power.

The CenCom Gold provides various output types (High Side/Positive and Low Side/Negative) to control lightbars, strobe lights, and accessories. High Current Outputs (Positive 12VDC) Ignition Trigger (+12V switched power to turn the

| Terminal | Label | Typical Function | Wiring Notes | | :--- | :--- | :--- | :--- | | | AC | 16.5V AC Input | Connect to a dedicated 40VA transformer. Do not use DC here. | | 2 | AC | 16.5V AC Input (Return) | Polarity does not matter for AC terminals. | | 3 | BELL+ | Siren / Bell Positive | Provides 12VDC for external sounders (current limited). | | 4 | BELL- | Siren / Bell Negative | Common ground for alarm output. | | 5 | AUX+ | Auxiliary Power (12VDC) | For powering PIRs, glassbreaks, or keypads (rated ~500mA-1A). | | 6 | AUX- | Common Negative (Ground) | Reference ground for all DC devices. | | 7 | Z1 | Zone 1 Input (Normally Closed) | Loop to Aux- via contact or EOL resistor (1k–2.2k typical). | | 8 | Z2 | Zone 2 Input | Same configuration as Z1. | | 9 | T | Tip (Phone Line – Ringing side) | Connects to Telco’s Red/Green pair. | | 10 | R | Ring (Phone Line – Ground side) | Standard RJ31X jack wiring: Red to T, Green to R. | | 11 | T1 | Tip to Premises (House Phones) | Connects to the “Tip” side of internal house wiring. | | 12 | R1 | Ring to Premises | Connects to the “Ring” side of internal house wiring. | | 13 | PGM | Programmable Output | Switched ground for strobes, resetting smoke detectors, etc. | | 14 | GND | Earth Ground | Critical for lightning protection; connect to cold water pipe or ground rod. |

Important: This is a general text guide. Consult the specific Cencom Gold model installation manual for exact terminal names, resistor values, voltage, and configuration steps. Locate a verified +12V ignition-switched source using a

Dedicated for controlling traffic arrow sticks.

Common issues with the Cencom Gold wiring diagram include:

What is the of the vehicle you are upfitting?

Secondary perimeter strobe supplies or high-power scene lights. 5 Circuits